Test unit Powercheck

 

The high-voltage test unit Powercheck is a performance testing unit for HAUG power packs. 

 

To test power packs, the black measuring probe with the spring pin must be inserted into the high-voltage socket of the power pack (photos 3, 4).


After pressing the red push button, the LED will illuminate green if the unit is functioning correctly. In case of malfunction, the LED will illuminate red.

Foto 1
Foto 1
Foto 2
Foto 2

Zusatzinformationen

Das Powercheck und Combicheck erhalten jeweils standardmäßig eine Kalibrierung. Beim Combicheck ist nur die Funktion "Testen von Netzteilen" kalibriert. Die Funktion "Testen von Ionisationsgeräten" ist nicht kalibrierfähig.

Zum Schutz der Geräte gegenüber Umgebungsfeuchte wird bei beiden Geräten die Mess-Sonde mit einer Schutzkappe geschützt.

Bei zu niedriger Batteriespannung leuchtet nach Drücken des roten Tasters an beiden Geräten (Powercheck und Combicheck) die LED nicht. Zum Wechseln der Batterie lässt sich der Batteriefachdeckel, nach Zurückdrücken der Einrastlasche, abnehmen.

Technical data Powercheck

Typ Powercheck Order-No.: 12.7230.000
Equipment with battery compartment, battery check indicator and calibration protocol
Current supply 9 Volt battery
Current consumption 15 mA
Housing dimensions 156 x 40 x 29 mm

 

Additional information for Powercheck and Combicheck

The Powercheck and the Combicheck are each calibrated as standard. In the case of the Combicheck, only the function “Testing of power packs” is calibrated. The function “Testing of ionizing units” cannot be calibrated.
To protect the units against ambient humidity, the measuring probe is protected with a cap in both units.
In the event of insufficient battery voltage, the diode does not light up after the red pushbutton is pressed on the two units (Powercheck and Combicheck). To change the battery, remove the battery compartment lid by pushing back the snap-in tab.