Charging device ALW

 

The resistance-coupled charging electrode ALW was created for use with the charging generator AGW. By limiting the current using resistors, the generation of hard sparks can be reliably prevented, thus significantly reducing possible damage to or impairment of electronic machine controls.

 

The charging electrode is connected with a detachable, shielded high-voltage cable and can be supplied with a radial or axial HV-connection. The bar profile is manufactured from glass fibre reincforced plastic which is also suitable for use at higher temperatures. A T-groove along the back of the ALW alllows convenient installation over the whole width of the bar.

Applications

The resistance-coupled charging electrode ALW is recommended, in particular, for applications with increased risk of spark generation and consequently of damage to high-grade surfaces of electronic components. Conceivable scenarios include situations where the counter-electrode required for charging is not always covered completely by the material to be charged, e.g. where two-dimensional material webs of varying width are charged or where there is an uncovered gap between cut or individual materials on the substrate acting as counter electrode.

 

Technical data

Types ALW
Charging electrode
with axial
cable connection
Order-No.: 08.8790.000
ALW
Charging electrode
with radial
cable connection
Order-No.: 08.8791.000
Bar profile Glass fibre reinforced plastic, compact design
Dimensions 30 x 64 mm
Length 80 to 2000 mm Length intervals: 30 mm
Operating temperature +5 °C to +45 °C
Storage/transport temperature -15 °C to +60 °C

Subject to technical changes!

Accessories

Single cable, axial Order-No.: 06.2268.001
Single cable, radial Order-No.: 06.2269.001

Download attachments: brochure operating instructions